Autonetics Certified Automation Engineering

Syllabus

1)PLC (Programmable Logic controller)

1. Introduction to PLC hardware
2. Architecture of PLC
3. PLC fundamentals
4. Information about PLC components
5. Types of input output
6. Source sink concepts in PLC
7. Flag concepts
8. Wiring Installation concept
9. Introduction to PLC Programming software
10. Addressing concepts
11. Introduction to Byte, bit & word concept
12. Detail Programming
13. Timer, counter ,block programming
14. Advanced Instruction
15. File handling
16. Upload download & Monitoring
17. Forcing Input output
18. Troubleshooting and fault diagnosis of plc
19. Programming assignments for real time application

2) SCADA (Supervisory Control and data Acquisition)

1. Introduction of SCADA software
2. Applications of SCADA software
3. Creating database of Tags
4. Creating and Editing graphics display with animation
5. Data entry / Start stop command / analog input
6. Sizing / movement / blinking/ visibility /filling
7. Trending
8. Script logic writing
9. Recipe management
10. Security management
11. Types of Window
12. Database connectivity
13. Communication with PLC
14. Troubleshooting

3) Electrical system

1. Electrical Fundamental:-
• Electrical system Measurements.
• Electrical parameter Calculations.
• Principle of AC generation.
• Front control and switching concept.

2. Switchgear/Protection device:-
• Electrical fault detection.
• Fuses
• MCB / MCCB / ACB
• Contactor / OLR / MPCB / ELCB

3. MOTOR and Starter:-
• AC motor types.
• DC motor types.
• Calculation of motor.
• Starter Principle
• Direct ON line(DOL).
• Star Delta circuit.
• Single phase Motor
• Split phase.
• Capacitor start.
• Shaded pole.
• Universal motor.

4. Transformer:-
• Basic types of transformer.
• Generator and characteristic.

4) Drives

1. Dc Motor
2. Ac Motor
3. Motor Review
4. Loads
5. Servo Motor
6. Stepper Motor
7. Requirements of Drive
8. Dc Drives
9. Ac Drives
10. Bypassing
11. User/operator interface